{{ name }}
Art-nr. {{ combinedCodeWithHighlight }}
Artikelnummer:
EAN/GTIN:
Tillverkarens nummer:
HiPer-Drill Grundelement 18 mm
Art-nr.: 231600 18
Artikelnummer:
- Version: 1.5×D
- Shank: ISO 9766
- Use for drilling: limited cross-drilling; limited drilling through a stack; limited drilling with oblique exit; limited oblique spot drilling
- Number of cutting edges Z: 2
- Through-coolant: yes
Produktdetaljer
Tekniska data
| Series | HiPer-Drill | |
| Version | 1.5×D | |
| Shank | ISO 9766 | |
| Use for drilling | limited cross-drilling; limited drilling through a stack; limited drilling with oblique exit; limited oblique spot drilling | |
| Number of cutting edges Z | 2 | |
| Through-coolant | yes | |
| Dia. range Dc | 18 mm - 18.99 mm | |
| Reach L1 | 29 mm | |
| Shank ⌀ Ds | 25 mm | |
| Shank length Ls | 56 mm | |
| Clamping screw | 231999 8IP1 (1.2 Nm) | |
| Overall length L | 114 mm | |
| Type of product | Indexable drill |
Identifieringsnummer och klassificeringar
| Artikelnummer | 231600 18 | |
| EAN/GTIN | 4045197602572 | |
| Tillverkarens nummer | 231600 18 |
Benämning
Version:
- Very high feed rates and maximum performance due to optimally matched geometries and materials.
- Precise positioning of the cutter insert due to Vee insert seating and secure clamping by the centre bore.
- High concentricity when assembled. (For holes up to IT9 accuracy)
- Shank support for optimum stability in operation.
Application:
For stationary and rotating use. For holes up to IT9 accuracy.
Note:
The insert screw must be replaced after every fifth change of cutter insert.
Further sizes up to ⌀ 50.99 mm available on request.
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.
Further sizes up to ⌀ 50.99 mm available on request.
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.
Nedladdningar och dokument
Jämför med liknande produkter
Den här artikeln |
Rekommendationer |
||
|---|---|---|---|
HiPer-Drill Grundelement 18 mm
på begäran
I lager
8 styck i lager
CHF 3’243.05
plus lagstadgad moms
Priser plus leveranskostnader
|
|||
| Dia. range Dc | 18 mm - 18.99 mm | 18 mm - 24 mm | 18 mm - 24 mm |
| Number of cutting edges Z | 2 | 2 | 2 |
| Version | 1.5×D | 1.5×D | 1.5×D |
| Through-coolant | yes | yes | yes |
| Shank | ISO 9766 | ISO 9766 | Morse taper |
| Reach L1 | 29 mm | 36 mm | 36 mm |
| Type of product | Indexable drill | Indexable drill | Indexable drill |