{{ name }}
Artikelnummer {{ combinedCodeWithHighlight }}
Klantartikelnummer:
EAN/GTIN:
Nummer fabrikant:
HiPer-Drill basiselement, 10×D, ⌀ DC: 19mm
Artikelnummer: 231617 19
Klantartikelnummer:
- Uitvoering: 10×D
- Schacht: ISO 9766
- Boortoepassing: beperkt dwarsboren; beperkt pakketboren; beperkt schuine uittrede; beperkt schuin aanboren
- Aantal snijkanten Z: 2
- Inwendige koeling: ja
Productdetails
Technische gegevens
| Serie | HiPer-Drill | |
| Uitvoering | 10×D | |
| Schacht | ISO 9766 | |
| Boortoepassing | beperkt dwarsboren; beperkt pakketboren; beperkt schuine uittrede; beperkt schuin aanboren | |
| Aantal snijkanten Z | 2 | |
| Inwendige koeling | ja | |
| ⌀-bereik Dc | 19 mm - 19,99 mm | |
| Nuttige lengte L1 | 200 mm | |
| Schacht-⌀ Ds | 25 mm | |
| Schachtlengte Ls | 56 mm | |
| Spanschroef | 231999 9IP (2,2 Nm) | |
| Totale lengte L | 286 mm | |
| Producttype | Wisselplaatboor |
Identificatienummers en classificaties
| Artikelnummer | 231617 19 | |
| EAN/GTIN | 4045197869005 | |
| Nummer fabrikant | 231617 19 |
Omschrijving
Version:
- Very high feed rates and maximum performance due to optimally matched geometries and materials.
- Precise positioning of the cutter insert due to Vee insert seating and secure clamping by the centre bore.
- High concentricity when assembled.
- Shank support for optimum stability in operation.
Polished flutes.
Application:
For stationary and rotating use. For holes up to IT9 accuracy.
Note:
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.
Further sizes up to ⌀ 50.99 mm available on request.
The insert screw must be replaced after every fifth change of cutter insert.
Reduce feed rates f by 10 % and vc values by 30 %.
For process reliability when using the drill, initial pilot drilling to 1.5×D with the drill No. 231600 with the same cutter insert size and type is necessary. The generation of a pilot hole improves process reliability.
For optimum stability, clamp the drill so the overhang is as short as possible.
Further sizes up to ⌀ 50.99 mm available on request.
The insert screw must be replaced after every fifth change of cutter insert.
Reduce feed rates f by 10 % and vc values by 30 %.
For process reliability when using the drill, initial pilot drilling to 1.5×D with the drill No. 231600 with the same cutter insert size and type is necessary. The generation of a pilot hole improves process reliability.