{{ name }}
Réf. {{ combinedCodeWithHighlight }}
Référence:
EAN / GTIN:
Réf. fabricant:
Round sheet metal punch with ball thrust bearing, Punch ⌀ (hole ⌀): 30mm
Réf.: 834100 30
Référence:
Détails du produit
Caractéristiques techniques
| Punch ⌀ (hole ⌀) | 30 mm | |
| Draw screw | M10×1×55 | |
| hole ⌀ to be pre-drilled | 11 mm | |
| Draw screw size | 17 mm | |
| for material thickness (sheet metal St 37) | 1.75 mm | |
| for stainless sheet steel depending on tensile strength up to | 1.25 mm | |
| Type of product | Punching tool |
Numéros d’identification et classifications
| Référence article | 834100 30 | |
| EAN / GTIN | 2050000992797 |
Description
Version:
Consisting of matrix, punch, and draw bolt.
With ball thrust bearing = for easier operation using a wrench. Friction between punch and screw is reduced, so less force is required.
With ball thrust bearing = for easier operation using a wrench. Friction between punch and screw is reduced, so less force is required.
Application:
For punching holes into diverse materials such as sheet steel, sheet stainless steel, sheet aluminium, sheet copper etc. Particularly useful where access is difficult (e.g. large sheet metal plates, control cabinets, fuse boxes, junction boxes, dashboards, sink basins, bodywork etc.). Not suitable for pipework. It is imperative to grease the pressure screw and matrix before use.
Operation:
a) using a wrench
b) using manual hydraulics No. 834655 size 1.
c) using a manual hydraulic drive No. 834700. From 50 mm ⌀ upwards the use of the manual hydraulic drive is recommended.
Operation:
a) using a wrench
b) using manual hydraulics No. 834655 size 1.
c) using a manual hydraulic drive No. 834700. From 50 mm ⌀ upwards the use of the manual hydraulic drive is recommended.
Material:
Special tool steel, burnished.
Note:
- When using hydraulic tools, use draw bolt No. 834070 (optional accessory) instead of the pressure screw.
- Size 32 and 35 for holes in stainless steel sinks, to attach 1/2 inch sink fitments.