{{ name }}
Cod articol {{ combinedCodeWithHighlight }}
Codul articolului:
EAN / GTIN:
Număr producător:
Burghiu suport HiPer-Drill, 10×D, ⌀ DC: 22mm
Cod articol: 231617 22
Codul articolului:
- Execuţie: 10×D
- Coadă tip: ISO 9766
- Utilizare găurire: Condiționată găurirea transversală; Condiționată găurirea în set; condiţionat ieşire oblică; condiţionat centruire oblică
- Number of cutting edges Z: 2
- Răcire interioară: da
Detalii despre produs
Date tehnice
| Series | HiPer-Drill | |
| Execuţie | 10×D | |
| Coadă tip | ISO 9766 | |
| Utilizare găurire | Condiționată găurirea transversală; Condiționată găurirea în set; condiţionat ieşire oblică; condiţionat centruire oblică | |
| Number of cutting edges Z | 2 | |
| Răcire interioară | da | |
| Dia. range Dc | 22 mm - 22.99 mm | |
| Reach L1 | 230 mm | |
| Shank ⌀ Ds | 25 mm | |
| Shank length Ls | 56 mm | |
| Clamping screw | 231999 10IP (3,3 Nm) | |
| Overall length L | 320 mm | |
| Tip produs | Burghiu cu plăcuţe amovibile |
Numere de identificare și clasificări
| Cod articol | 231617 22 | |
| EAN / GTIN | 4045197869036 | |
| Număr producător | 231617 22 |
Descriere
Version:
- Very high feed rates and maximum performance due to optimally matched geometries and materials.
- Precise positioning of the cutter insert due to Vee insert seating and secure clamping by the centre bore.
- High concentricity when assembled.
- Shank support for optimum stability in operation.
Polished flutes.
Application:
For stationary and rotating use. For holes up to IT9 accuracy.
Note:
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.
Further sizes up to ⌀ 50.99 mm available on request.
The insert screw must be replaced after every fifth change of cutter insert.
Reduce feed rates f by 10 % and vc values by 30 %.
For process reliability when using the drill, initial pilot drilling to 1.5×D with the drill No. 231600 with the same cutter insert size and type is necessary. The generation of a pilot hole improves process reliability.
For optimum stability, clamp the drill so the overhang is as short as possible.
Further sizes up to ⌀ 50.99 mm available on request.
The insert screw must be replaced after every fifth change of cutter insert.
Reduce feed rates f by 10 % and vc values by 30 %.
For process reliability when using the drill, initial pilot drilling to 1.5×D with the drill No. 231600 with the same cutter insert size and type is necessary. The generation of a pilot hole improves process reliability.