{{ name }}
Artikkelnr. {{ combinedCodeWithHighlight }}
Artikkelkode:
EAN / GTIN:
Manufacturer number:
HiPer-Drill base body 9 mm
Article no.: 231605 9
Artikkelkode:
- Utförande: 3×D
- Skaft: ISO 9766
- Borranvändning: kräver kryssborrning; kräver paketborrning; kräver snedställd utgång; kräver snedställd borrstart
- Number of cutting edges Z: 2
- Invändig: ja
Produktinformasjon
Technical Data
| Series | HiPer-Drill | |
| Utförande | 3×D | |
| Skaft | ISO 9766 | |
| Borranvändning | kräver kryssborrning; kräver paketborrning; kräver snedställd utgång; kräver snedställd borrstart | |
| Number of cutting edges Z | 2 | |
| Invändig | ja | |
| Dia. range Dc | 9 mm - 9.49 mm | |
| Reach L1 | 29 mm | |
| Shank ⌀ Ds | 12 mm | |
| Shank length Ls | 45 mm | |
| Clamping screw | 231999 5IP1 (0.2 Nm) | |
| Overall length L | 92 mm | |
| Produktslag | Vändskärsborrar |
Identification numbers & Classifications
| Artikkelkode | 231605 9 | |
| EAN / GTIN | 4045197715388 | |
| Manufacturer number | 231605 9 |
Beskrivelse
Version:
- Very high feed rates and maximum performance due to optimally matched geometries and materials.
- Precise positioning of the cutter insert due to Vee insert seating and secure clamping by the centre bore.
- High concentricity when assembled. (For holes up to IT9 accuracy)
- Shank support for optimum stability in operation.
Created by an additive procedure.
Application:
For stationary and rotating use. For holes up to IT9 accuracy.
Note:
The insert screw must be replaced after every fifth change of cutter insert.
Further sizes up to ⌀ 50.99 mm available on request.
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.
Further sizes up to ⌀ 50.99 mm available on request.
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.