{{ name }}
Art.-nr. {{ combinedCodeWithHighlight }}
Sagsnummer:
EAN/GTIN:
Producentnummer:
HiPer-Drill basiselement, 10×D, ⌀ DC: 23mm
Art.-nr.: 231617 23
Sagsnummer:
- Udførelse: 10×D
- Skaft: ISO 9766
- Boranvendelse: Betinget tværboring; Betinget pakkeboring; Betinget skrå udgang; Betinget skrå forboring
- Antal skær Z: 2
- Indvendig køling: ja
Produktdetaljer
Teknisk data
| Serie | HiPer-Drill | |
| Udførelse | 10×D | |
| Skaft | ISO 9766 | |
| Boranvendelse | Betinget tværboring; Betinget pakkeboring; Betinget skrå udgang; Betinget skrå forboring | |
| Antal skær Z | 2 | |
| Indvendig køling | ja | |
| ⌀-område Dc | 23 mm - 23,99 mm | |
| Nyttelængde L1 | 240 mm | |
| Skaft-⌀ Ds | 25 mm | |
| Skaftlængde Ls | 56 mm | |
| Spændeskrue | 231999 10IP (3,3 Nm) | |
| Samlet længde L | 331 mm | |
| Produkttype | Vendeplattebor |
Identifikationsnumre og klassifikationer
| Artikelnummer | 231617 23 | |
| EAN/GTIN | 4045197869043 | |
| Producentnummer | 231617 23 |
Betegnelse
Version:
- Very high feed rates and maximum performance due to optimally matched geometries and materials.
- Precise positioning of the cutter insert due to Vee insert seating and secure clamping by the centre bore.
- High concentricity when assembled.
- Shank support for optimum stability in operation.
Polished flutes.
Application:
For stationary and rotating use. For holes up to IT9 accuracy.
Note:
Further sizes up to ⌀ 50.99 mm available on request.
The insert screw must be replaced after every fifth change of cutter insert.
For process reliability when using the drill, initial pilot drilling to 1.5×D with the drill No. 231600 with the same cutter insert size and type is necessary. The generation of a pilot hole improves process reliability.
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.
Reduce feed rates f by 10 % and vc values by 30 %.
The insert screw must be replaced after every fifth change of cutter insert.
For process reliability when using the drill, initial pilot drilling to 1.5×D with the drill No. 231600 with the same cutter insert size and type is necessary. The generation of a pilot hole improves process reliability.
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.
Reduce feed rates f by 10 % and vc values by 30 %.