{{ name }}
Article no. {{ combinedCodeWithHighlight }}
Article code:
EAN / GTIN:
Manufacturer number:
Torque screwdriver with scale, to take D 6.3 bits, ESD 500 cNm
Article no.: 659917 500
Article code:
- electrostatic characteristic: EGB/ESD
Product details
Technical Data
| Manufacturer's designation | MecaTorque ESD | |
| maximum torque | 500 cNm | |
| electrostatic characteristic | EGB/ESD | |
| Direction of tightening | Right-hand tightening | |
| Torque measuring accuracy | ±6 % | |
| Bit socket | D 6,3 | |
| Test certificate | Manufacturer’s test certificate | |
| Overall length L | 144 mm | |
| Torque range | 100 cNm - 500 cNm | |
| Torque range | 1 Nm - 5 Nm | |
| Scale graduation, 1 graduation = | 10 cNm | |
| Display | analogue | |
| Release signalling | akustisk; haptisk | |
| Trigger principle | mechanical slip clutch | |
| Connection format | Bit holder 1/4 inch | |
| Measurement technology | mechanical | |
| Torque fixed setting | no | |
| Data can be recorded | no | |
| Setting the trigger value | with adjustment scale | |
| Feedback | triggering | |
| Reversible reading | Nm | |
| Measurement process | Torque | |
| Adjustable trigger value | adjustable | |
| Standard | DIN EN ISO 6789 | |
| Weight | 119 g | |
| Type of product | Torque screwdriver |
Identification numbers & Classifications
| Article number | 659917 500 | |
| EAN / GTIN | 7610733269471 | |
| Manufacturer number | 8317.M 500 ESD |
Description
Version:
Power grip with non-allergenic elastomer coating allows transmission of the required torque with no problems even with wet or oily hands. On reaching the set torque value, the screwdriver can be felt and heard to trigger and is then again immediately ready for use. The release torque is higher than the tightening torque (overload protection).
Suitable for ESD work.
The desired torque is set using an adjustment wheel at the end of the handle. Putting the wheel into the locked position prevents inadvertent changes to the setting. Easy to read micrometer scale, protected against dirt.
Bit holder with magnet to take C 6.3 bits.
Suitable for ESD work.
The desired torque is set using an adjustment wheel at the end of the handle. Putting the wheel into the locked position prevents inadvertent changes to the setting. Easy to read micrometer scale, protected against dirt.
Bit holder with magnet to take C 6.3 bits.
Application:
For controlled tightening of screws to a pre-set torque.
Standard:
Tested to DIN EN ISO 6789.
Note:
The guaranteed measuring accuracy of the torque is achieved only once the torque range has been calibrated to DIN EN ISO 6789.