{{ name }}
Número de artículo {{ combinedCodeWithHighlight }}
Código del artículo:
EAN / GTIN:
Número del fabricante:
HiPer-Drill base body 35 mm
Número de artículo: 231617 35
Código del artículo:
- Ejecución: 10×D
- Mango: ISO 9766
- Empleo de taladro: taladrado transversal con restricciones; taladrado de piezas en paquete con restricciones; salida inclinada con restricciones; inicio de taladrado inclinado con restricciones
- Número de filos Z: 2
- Refrigeración interior: sí
Detalles de producto
Datos técnicos
| Serie | HiPer-Drill | |
| Ejecución | 10×D | |
| Mango | ISO 9766 | |
| Empleo de taladro | taladrado transversal con restricciones; taladrado de piezas en paquete con restricciones; salida inclinada con restricciones; inicio de taladrado inclinado con restricciones | |
| Número de filos Z | 2 | |
| Refrigeración interior | sí | |
| Intervalo ⌀ Dc | 35 mm - 35,99 mm | |
| Longitud útil L1 | 360 mm | |
| ⌀ de mango Ds | 32 mm | |
| Longitud del mango Ls | 60 mm | |
| Tornillo de amarre | 231999 20IP1 (7,5 Nm) | |
| Longitud total L | 469 mm | |
| Tipo de producto | Brocas de plaquitas reversibles |
Números de identificación y clasificaciones
| Número de artículo | 231617 35 | |
| EAN / GTIN | 4045197869166 | |
| Número del fabricante | 231617 35 |
Descripción
Version:
- Very high feed rates and maximum performance due to optimally matched geometries and materials.
- Precise positioning of the cutter insert due to Vee insert seating and secure clamping by the centre bore.
- High concentricity when assembled.
- Shank support for optimum stability in operation.
Polished flutes.
Application:
For stationary and rotating use. For holes up to IT9 accuracy.
Note:
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.
Further sizes up to ⌀ 50.99 mm available on request.
The insert screw must be replaced after every fifth change of cutter insert.
Reduce feed rates f by 10 % and vc values by 30 %.
For process reliability when using the drill, initial pilot drilling to 1.5×D with the drill No. 231600 with the same cutter insert size and type is necessary. The generation of a pilot hole improves process reliability.
For optimum stability, clamp the drill so the overhang is as short as possible.
Further sizes up to ⌀ 50.99 mm available on request.
The insert screw must be replaced after every fifth change of cutter insert.
Reduce feed rates f by 10 % and vc values by 30 %.
For process reliability when using the drill, initial pilot drilling to 1.5×D with the drill No. 231600 with the same cutter insert size and type is necessary. The generation of a pilot hole improves process reliability.