{{ name }}
Article no. {{ combinedCodeWithHighlight }}
Article code:
EAN / GTIN:
Manufacturer number:
Hardened top jaw set, 3 pieces, for chuck type: 400
Article no.: 313210 400
Article code:
Product details
Technical Data
| for chuck type | 400 mm | |
| Length L | 130 mm | |
| Width B | 45 mm | |
| Slot width D | 18 mm | |
| Bore spacing b | 60 mm | |
| Tenon length A | 30 mm | |
| suitable for colour code | Röhm self-centring chucks and jaws; Schunk self-centring chucks and jaws | |
| Type of product | Self-centring chuck jaws |
Identification numbers & Classifications
| Article number | 313210 400 | |
| EAN / GTIN | 2050001929082 | |
| Manufacturer number | 0155104 |
Description
Application:
As the jaws can be changed or adjusted to the required diameter in just a few seconds, it is useful to have several jaw sets on hand ready for use at the machine. This minimises set-up times. The jaw units consist for example of several sets of base jaws with soft top jaws, which can be machined out to the required diameters. This rationalisation method is not only necessary for NC machines but also important for every lathe type.
For fitting to hardened base jaws. Applicable as reversible jaws in conjunction with the base jaws.
For fitting to hardened base jaws. Applicable as reversible jaws in conjunction with the base jaws.
Suitable for:
Schunk self-centring chucks No. 313115; 313117; 313135; 313137, Röhm self-centring chucks Duro No. 313120; 313140 and other self-centring chuck systems.
Note:
- Hard top and stepped jaws purchased subsequently must be ground internally in the chuck for concentricity and run-out.