{{ name }}
Article no. {{ combinedCodeWithHighlight }}
Article code:
EAN / GTIN:
Manufacturer number:
HiPer-Drill base body 18 mm
Article no.: 231610 18
Article code:
- Version: 5×D
- Shank: ISO 9766
- Use for drilling: limited cross-drilling; limited drilling through a stack; limited drilling with oblique exit; limited oblique spot drilling
- Number of cutting edges Z: 2
- Through-coolant: yes
Product details
Technical Data
| Series | HiPer-Drill | |
| Version | 5×D | |
| Shank | ISO 9766 | |
| Use for drilling | limited cross-drilling; limited drilling through a stack; limited drilling with oblique exit; limited oblique spot drilling | |
| Number of cutting edges Z | 2 | |
| Through-coolant | yes | |
| Dia. range Dc | 18 mm - 18.99 mm | |
| Reach L1 | 95 mm | |
| Shank ⌀ Ds | 25 mm | |
| Shank length Ls | 56 mm | |
| Clamping screw | 231999 8IP1 (1.2 Nm) | |
| Overall length L | 180 mm | |
| Type of product | Indexable drill |
Identification numbers & Classifications
| Article number | 231610 18 | |
| EAN / GTIN | 4045197603012 | |
| Manufacturer number | 231610 18 |
Description
Version:
- Very high feed rates and maximum performance due to optimally matched geometries and materials.
- Precise positioning of the cutter insert due to Vee insert seating and secure clamping by the centre bore.
- High concentricity when assembled. (For holes up to IT9 accuracy)
- Shank support for optimum stability in operation.
Application:
For stationary and rotating use. For holes up to IT9 accuracy.
Note:
The insert screw must be replaced after every fifth change of cutter insert.
Further sizes up to ⌀ 50.99 mm available on request.
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.
Further sizes up to ⌀ 50.99 mm available on request.
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.
Downloads & documents
Compare with similar products
This article |
Recommendations |
|
|---|---|---|
HiPer-Drill base body 18 mm |
||
| Dia. range Dc | 18 ;18.99 | 18 ;24 |
| Number of cutting edges Z | 2 | 2 |
| Through-coolant | yes | yes |
| Shank | ISO 9766 | ISO 9766 |
| Shank ⌀ Ds | 25 | 25 |
| Shank length Ls | 56 | 56 |
| Reach L1 | 95 | 168.3 |