{{ name }}
Article no. {{ combinedCodeWithHighlight }}
Article code:
EAN / GTIN:
Manufacturer number:
Tool breakage monitoring XCONTROL, Type: 1
Article no.: 359400 1
Copy
Article code:
Copy
- IP Index of Protection: IP 67
Product details
Technical Data
| Series | Xcontrol | |
| ⌀ spring-mounted contact face | 29 mm | |
| Length | 71.5 mm | |
| Width | 53 mm | |
| Height | 105 mm | |
| minimum bore ⌀ | 0.3 mm | |
| Measuring accuracy for length measurement | ± 0.01 mm | |
| Repetition accuracy for length measurement | ± 0.005 mm | |
| IP Index of Protection | IP 67 | |
| Power supply | Battery-powered | |
| Type of product | Probes |
Identification & Classification
| Article number |
359400 1
Copy |
|
| EAN / GTIN |
4062406370596
Copy |
|
| Manufacturer number |
359400 1
Copy |
|
| Manufacturer/responsible person | Hoffmann Supply Chain GmbH & Co. KG, Poststraße 15, 90471 Nürnberg, Germany, www.hoffmann-group.com |
Description
Version:
XCONTROL – tactile tool contact point for tool breakage monitoring and tool length measurement. Measurement accuracy +/- 0.01 mm and repetition accuracy +/- 0.005 mm.
- Suitable only for Siemens and Heidenhain controllers.
- The machine requires a functioning USB port on the control panel.
- For use only in conjunction with the XCONNECT No. 359455 1.
- Dust-tight and watertight = IP67.
- Quick commissioning without hardware changeover and service engineer use.
- No need to interfere with the machine tool operating system!
- Drills from ⌀ 0.3 mm can be measured or tested.
Function:
IP67: Protected against intermittent immersion in water and protected against penetration by dust (dust-tight), also completely protected against touching.
Application:
For tool breakage and process monitoring in an automated machine tool or for multi-machine operation.
For tool length measurement and automatic transmission of data to a machine tool.
Automatic transmission of the measured values into the machine control by GARANT Xconnect No. 359455 1.
For tool length measurement and automatic transmission of data to a machine tool.
Automatic transmission of the measured values into the machine control by GARANT Xconnect No. 359455 1.
Supplied with:
Supplied with battery CR2.
Optional extras:
Note:
The item is permanently installed on a machine and can only be used on another machine through another cycle request.
Warning:
Intended use
Reasonably foreseeable misuse
- Use only when it is technically in good condition and safe to operate.
- For work in industrial environments.
- Use only on a flat and clean base.
- Use only when correctly assembled and with safety devices and guards on the machine fully operational.
- Use only original spare parts and wearing parts.
Reasonably foreseeable misuse
- Do not use in explosion hazard areas.
- Not for use in areas where high concentrations of dust, flammable gases, vapours or solvents are present.
- Do not subject it to blows, impacts or heavy loads.
- Do not make any unauthorised modifications.