{{ name }}
Réf. {{ combinedCodeWithHighlight }}
Référence:
EAN / GTIN:
Réf. fabricant:
Alésoir conique à hélice 10 mm
Réf.: 161600 10
Référence:
- Tool material: HSS E
- Standard: DIN 2179
- Helix angle: 45
- Taper ratio: 1:50
- Through-coolant: no
Détails du produit
Caractéristiques techniques
| small ⌀ D3 | 9.9 mm | |
| large ⌀ D2 | 13.4 mm | |
| Nominal ⌀ DC | 10 mm | |
| Coating | uncoated | |
| Tool material | HSS E | |
| Standard | DIN 2179 | |
| Helix angle | 45 degrees | |
| Taper ratio | 1:50 | |
| Through-coolant | no | |
| Shank | Parallel shank to h9 | |
| Flute length Lc | 175 mm | |
| Overall length L | 245 mm | |
| Shank ⌀ Ds | 12.5 mm | |
| Feed f in steel < 500 N/mm2 | 0.15 mm/rev. | |
| Colour ring | without | |
| Type of product | Phillips bit |
Numéros d’identification et classifications
| Référence article | 161600 10 | |
| EAN / GTIN | 4045197089083 | |
| Réf. fabricant | 161600 10 |
Tableau d’application
N
20
N
20
P
15
P
10
P
7
Description
Version:
With 45° left hand helix, evacuates swarf in cutting direction.
Application:
On machines for tapered through holes. The peeling twist requires removal of a thick chip (pre-drilled hole must not be too large). For taper pins to ISO 2339, 8736, 8737 (DIN 1, 7977, 7978), DIN 258 and 1447.
Recommendation:
The pre-drilled hole is best produced using a straight shank taper pin drill No. 116310.