{{ name }}
Número de artículo {{ combinedCodeWithHighlight }}
Código del artículo:
EAN / GTIN:
Número del fabricante:
Elemento de base HiPer-Drill 15 mm
Número de artículo: 231615 15
Código del artículo:
- Ejecución: 8×D
- Mango: ISO 9766
- Empleo de taladro: taladrado transversal con restricciones; perforación de paquetes con restricciones; salida inclinada con restricciones; centrar inclinado con restricciones
- Número de filos Z: 2
- Refrigeración interior: sí
Detalles de producto
Datos técnicos
| Serie | HiPer-Drill | |
| Ejecución | 8×D | |
| Mango | ISO 9766 | |
| Empleo de taladro | taladrado transversal con restricciones; perforación de paquetes con restricciones; salida inclinada con restricciones; centrar inclinado con restricciones | |
| Número de filos Z | 2 | |
| Refrigeración interior | sí | |
| Intervalo ⌀ Dc | 15 mm - 15,99 mm | |
| Longitud útil L1 | 128 mm | |
| ⌀ de mango Ds | 20 mm | |
| Longitud del mango Ls | 50 mm | |
| Tornillo de amarre | 231999 8IP (0,9 Nm) | |
| Longitud total L | 203 mm | |
| Tipo de producto | Brocas de plaquitas reversibles |
Números de identificación y clasificaciones
| Número de artículo | 231615 15 | |
| EAN / GTIN | 4045197603203 | |
| Número del fabricante | 231615 15 |
Descripción
Version:
- Very high feed rates and maximum performance due to optimally matched geometries and materials.
- Precise positioning of the cutter insert due to Vee insert seating and secure clamping by the centre bore.
- High concentricity when assembled.
- Shank support for optimum stability in operation.
Application:
For stationary and rotating use. For holes up to IT9 accuracy.
Recommendation:
Drill the pilot hole.
Note:
Further sizes up to ⌀ 50.99 mm available on request.
The insert screw must be replaced after every fifth change of cutter insert.
reduce vf values by 20 %.
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.
For process reliability when using the drill, initial pilot drilling to 1.5×D with the drill No. 231600 with the same cutter insert size and type is necessary. The generation of a pilot hole improves process reliability.
The insert screw must be replaced after every fifth change of cutter insert.
reduce vf values by 20 %.
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.
For process reliability when using the drill, initial pilot drilling to 1.5×D with the drill No. 231600 with the same cutter insert size and type is necessary. The generation of a pilot hole improves process reliability.