{{ name }}
Número de artículo {{ combinedCodeWithHighlight }}
Código del artículo:
EAN / GTIN:
Número del fabricante:
HiPer-Drill base body 19 mm
Número de artículo: 231605 19
Código del artículo:
- Ejecución: 3×D
- Mango: ISO 9766
- Empleo de taladro: taladrado transversal con restricciones; perforación de paquetes con restricciones; salida inclinada con restricciones; centrar inclinado con restricciones
- Number of cutting edges Z: 2
- Refrigeración interior: sí
Detalles de producto
Datos técnicos
| Series | HiPer-Drill | |
| Ejecución | 3×D | |
| Mango | ISO 9766 | |
| Empleo de taladro | taladrado transversal con restricciones; perforación de paquetes con restricciones; salida inclinada con restricciones; centrar inclinado con restricciones | |
| Number of cutting edges Z | 2 | |
| Refrigeración interior | sí | |
| Dia. range Dc | 19 mm - 19.99 mm | |
| Reach L1 | 60 mm | |
| Shank ⌀ Ds | 25 mm | |
| Shank length Ls | 56 mm | |
| Clamping screw | 231999 9IP (2.2 Nm) | |
| Overall length L | 146 mm | |
| Tipo de producto | Brocas de plaquitas reversibles |
Números de identificación y clasificaciones
| Número de artículo | 231605 19 | |
| EAN / GTIN | 4045197602800 | |
| Número del fabricante | 231605 19 |
Descripción
Version:
- Very high feed rates and maximum performance due to optimally matched geometries and materials.
- Precise positioning of the cutter insert due to Vee insert seating and secure clamping by the centre bore.
- High concentricity when assembled. (For holes up to IT9 accuracy)
- Shank support for optimum stability in operation.
Application:
For stationary and rotating use. For holes up to IT9 accuracy.
Note:
The insert screw must be replaced after every fifth change of cutter insert.
Further sizes up to ⌀ 50.99 mm available on request.
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.
Further sizes up to ⌀ 50.99 mm available on request.
Clamp in a hydraulic chuck (such as No. 302026 size 20) for optimum radial run-out.
For optimum stability, clamp the drill so the overhang is as short as possible.