{{ name }}
Article no. {{ combinedCodeWithHighlight }}
Article code:
EAN / GTIN:
Manufacturer number:
Revolving lathe centre with digital pressure indicator and extended point 4
Article no.: 321720 4
Article code:
- IP Index of Protection: IP 55
- Power supply: energy-harvesting
Product details
Technical Data
| Morse taper | MT4 | |
| IP Index of Protection | IP 55 | |
| Power supply | energy-harvesting | |
| Body ⌀ | 70 mm | |
| Reach B | 149 mm | |
| largest centre point ⌀ 60° A | 35 mm | |
| largest centre point ⌀ 40° A | 14 mm | |
| maximum radial run-out | 0.005 mm | |
| Centre point length C | 45 mm | |
| for workpiece weight | 500 kg | |
| maximum axial clamping force | 1,080 daN | |
| Type of product | Centring drill |
Identification numbers & Classifications
| Article number | 321720 4 | |
| EAN / GTIN | 4062406127510 | |
| Manufacturer number | 321720 4 |
Description
Version:
- The momentary clamping pressure is directly readable on the analogue or digital display on the base body.
- The live centre is supported by a disc spring pack with a spring travel of approx. 3.7 mm analogue and 2.6 mm or 2.8 mm digital.
- Short sturdy design with active longitudinal axis. Live centre through hardened and finish ground.
- Maximum accuracy due to precision roller bearings.
- With push-off thread and push-off nut.
- With special seal against dirt and coolant ingress, maintenance-free due to lifetime lubrication.
With extended centre, point angle 60°/40°.
Description:
Lathe centres are mainly used on lathes to support long and slim workpieces, since with these workpieces there would otherwise be a risk of the workpiece bending or moving around as a result of the forces generated.
The lathe centre is secured with a Morse taper. The workpiece is clamped in the chuck and a counterbore is added using a centre drill. After re-clamping, the lathe centre is then inserted.
The lathe centre is secured with a Morse taper. The workpiece is clamped in the chuck and a counterbore is added using a centre drill. After re-clamping, the lathe centre is then inserted.
Function:
IP55: Protected against jets of water from all directions and protected against penetration of dust into the inside (protected against dust), also completely protected against touching.
Application:
Whenever the clamping force should be kept within certain limits,either to prevent deformation of the component or to ensure secure clamping with sufficient pressure.
- As a tailstock centre in conjunction with hydro-mechanical face drivers No. 327451 − 327541 because the drive teeth have to dig into the component.
- For components that expand significantly due to high machining heat.
- For clamping long slender components to prevent lateral displacement.
- For clamping heavy components where a controlled clamping force is required.